How do I know if I have a water line for my refrigerator?
Check around where the refrigerator is placed to see if there is an existing water supply line extending from the wall or up from the floor. If there is a water supply valve already installed behind your fridge, simply connect the supply valve to the refrigerator valve with 1/4-inch water line supply tubing.
Where is the shut off valve on my Refrigerator?
This shut-off valve is usually located under the kitchen sink, in the basement, in a crawl space, or in the cabinet next to the refrigerator. It will be connected to the cold water line.
How do you shut off the water line in a refrigerator?
Once you locate the refrigerator water line shut-off valve, pause. Prior to shutting off the valve, it’s a good idea to turn off the icemaker because otherwise it will continue to cycle on, which can damage the valve. When you’re ready to shut off the valve, simply turn it in a clockwise direction until it stops.
How do you shut off a water valve?
Most water valves are easy to shut off. If the valve uses a lever to turn it on or off, simply rotate the lever to shut it off. Some valves use a knob. Rotate the knob clockwise to shut it off. Sometimes, the lever or the knob can be hard to rotate because it has not been used for a long time.
What to do if your refrigerator water valve is not working?
If the valve is in one piece and not possible to take apart, you can use a wrench or pliers to rotate it back and forth, gradually increasing the amount of movement to try and make it move freely. Grip the lever or the knob using any gripping device and turn it slowly until the lever or knob comes loose.
How do you replace a water valve in a refrigerator?
Connect the two wire harnesses to the terminals on the side of the replacement ice and water valve. Line up the screw holes in the valve bracket with the screw holes in the body of the refrigerator. Secure the replacement valve with the hex-head screws you removed from the original valve.
How do you turn off the water line in a refrigerator?
Turn the cold water supply valve on beneath the sink. Let 1 or 2 gallons of water run through the new line to remove the air. Turn off the supply line. Slip the remaining compression nut and ferrule over the refrigerator end of the new water line.
Where is the water supply valve on a refrigerator?
The water inlet valve is an electronically operated device that connects the household water supply to your fridge if you have an icemaker and/or water dispenser. This valve is usually located at the back of the fridge near the bottom.
How do you replace the main water shutoff valve?
1. Shut off the water leading to the valve being replaced. 2. Use emery cloth to buff clean the pipe on either side of the old valve. 3. Cut through the pipe on each side of the old valve with a mini hacksaw. 4. Slip new stop-and-waste valve into place between the just-cut pipe ends.
