How do you remove motor from fifth wheel landing gear?
2. Remove plastic retainer that secures gearbox onto drive shaft so motor assembly can be removed from leg. A small screw holds this in place. 3. Slide gearbox with motor attached off the drive shaft, moving the shaft to opposite leg aside as necessary. The manual override drive shaft attached to the gearbox will easily slide out of its housing.
Where to buy new fifth wheel landing legs?
We stopped in at a nice RV park called Maverick Ranch in Lajitas, Texas, leaving the truck hooked up and I ordered up some new legs from Etrailer.com. I had used them in the past and was very pleased with their parts quality and customer service. They had replacements in stock from Stromberg Carlson priced at $134 each.
Why is my fifth wheel landing gear gearbox going bad?
Upon hearing such a noise, watch the motor as you extend the legs. If the motor assembly dances about in tune with the chunkity chunk chunk, the gearbox is probably going bad.
How do you replace a fifth wheel motor gearbox?
I took the following steps to replace our gearbox, and offer a few tips and precautions below to help anyone who may need to do the same. 1. Remove the retaining bolt from the sliding sheath on the square shaft that drives the opposite leg. Slide the sheath back to expose the gearbox drive shaft that powers leg movement.
What kind of landing gear do you need for a fifth wheel?
Landing gear reduces jack stress on your camper or fifth wheel trailer jacks by supporting the front of the trailer, while in a campground or while stored. Made from heavy duty steel and can be set up in minutes. Both manual and power is available – our RV parts store offers a wide variety of landing gear for all kinds of RV trailers.
What to do about broken fifth wheel landing leg?
I surmised that a small metal pin needed to be punched out to get the ball rolling sort of speak. Sure enough, once I punched out the pin on the top beveled gear and another below the larger lower beveled gear, the rest of the mechanism could be easily taken apart exposing the long worm gear.
How big is the etrailer landing gear set?
Atwood electric motor bolted right in. Overall very happy with the landing gear, as it was cheaper than just the replacement driver leg Atwood that was broke. 414274 This landing gear set according to the paperwork in the box is only rated at 5000# with a single motor.
Where can I get new fifth wheel legs?
Researching online I found some replacements by a company called Stromberg Carlson. They had a blueprint with all the key measurements and they matched mine exactly. We stopped in at a nice RV park called Maverick Ranch in Lajitas, Texas, leaving the truck hooked up and I ordered up some new legs from Etrailer.com.
2. Remove plastic retainer that secures gearbox onto drive shaft so motor assembly can be removed from leg. A small screw holds this in place. 3. Slide gearbox with motor attached off the drive shaft, moving the shaft to opposite leg aside as necessary. The manual override drive shaft attached to the gearbox will easily slide out of its housing.
How do you retract a landing gear motor?
If you have moved the motor after attaching the gearbox to the leg, ensure that both legs are the same length before proceeding. Measure the distance from the frame to the lower end of the sliding section on the opposite leg, and extend or retract the leg with the motor attached to match. 8.
Upon hearing such a noise, watch the motor as you extend the legs. If the motor assembly dances about in tune with the chunkity chunk chunk, the gearbox is probably going bad.
How do you remove a motor from a gearbox?
Remove plastic retainer that secures gearbox onto drive shaft so motor assembly can be removed from leg. A small screw holds this in place. 3. Slide gearbox with motor attached off the drive shaft, moving the shaft to opposite leg aside as necessary. The manual override drive shaft attached to the gearbox will easily slide out of its housing.
