How often should I Check my Norcold refrigerator?
Your refrigerator will give you years of trouble-free service if you do the following simple checks every three to six months. Refer to the operator’s guide provided with your refrigerator for more details: Keep the food compartment and the freezer clean. See “Cleaning.”
Why does my Norcold refrigerator not cool down?
Warm foods, high ambient temperatures, and frequent door openings will increase the cooldown time. Do not cover the shelves with plastic, paper, etc. If the unit does not start to cool after two hours, contact your dealer or a Norcold authorized service center. How level must the refrigerator be??
When does a refrigerator go from AC to DC?
When both power sources are supplied to the refrigerator it defaults to AC power. When the refrigerator is disconnected from shoreline power and AC is no longer available the refrigerator switches to DC operation.
How long does it take for a new refrigerator to cool down?
On initial start-up, allow the refrigerator to cool for 8-12 hours on the coldest temperature setting before loading it with food. Warm foods, high ambient temperatures, and frequent door openings will increase the cooldown time.
What kind of power does a Norcold refrigerator use?
Norcold gas absorption refrigerators operate off of 12V DC power (battery power). The AC plug that you see in the back is only powering your AC Heater/s that will cool the refrigerator when running it on AC or Auto Mode. The 12V DC powers the rear power board, the front control board, and the interior light.
How to troubleshoot your AC / DC Norcold refrigerator?
Make sure the power switch/thermostat is not in the OFF position. Make sure that the refrigerator is correctly installed and that the vents are not blocked. Make sure that the power source to the refrigerator is serviceable. Make sure that the fuse or circuit breaker is intact (See “Over current protection system” section).
Where is the thermal switch on a Norcold refrigerator?
If you have an N611, N621, N641, NX641, NXA641, N811, N821, N822, N841, NX841, NXA841, or N1095, you may have a thermal switch located at the flu. Simply follow the two lines coming from your 12V DC + and – terminals on the board to the right. You may have a push button switch that has gone off.
On initial start-up, allow the refrigerator to cool for 8-12 hours on the coldest temperature setting before loading it with food. Warm foods, high ambient temperatures, and frequent door openings will increase the cooldown time.
