How to fix clicking noise with AC on behind glove compartment?

How to fix clicking noise with AC on behind glove compartment?

86 people found this helpful. bad relay,drop glove box down,you will see the clips on both sides on it they rubber,easy to drop,turn ac on feel the relays to find clicking one,replace.is a dealer only part,all relays are.go to salvage yard ,get one. 114 people found this helpful.

What can I do if my AC Fan is not working?

You can pull the drawer down by carefully dislodging the stop clips found at the upper edge of the drawer on either side. Squeeze the top sides in a bit to allow the compartment to swing out and down to reveal the wiring behind. Now the resistor board part is fastened to the air vent with two Philips screws.

Where is the fan blower motor on my AC?

All fuses good all relays good. The fan blower for your ac/heater is located under the glovebox. Take your hand and smack the fan blower motor a few times. That’s all it took for for mine to start working again. It’s been working for over 6 month’s now!

How does the speed control on an AC fan work?

The speed control chooses the speed of the motor by changing the resistance in series with the DC fan motor. These resistors are all attached to one board with shovel plug attachments and the whole assembly is stuck in the air vent to keel them cool. The motor drives the air to cook its own resistors.

Why does my Rad fan stop running high?

Vacuumed it down, and noticed a small release of the vacuum. We put 24ozs of Freon in and the high fan speed stopped running high speed. So I waited till the next day went to his shop which was 90 miles away. The ac worked great on the way there. Vacated the system down again and removed the expansion valve.

Where is the Rad fan located on a Ford F-150?

On one of my vehicles it is located on the Thermostat housing, your’s can be elsewhere. The fan is designed to click on when the sensor detects the engine is over heading. It sends a signal to the vehicle’s computer which turns on the fan. If the sensor is defective it could send an overheat command, thus causing the fan to become active.

How much does it cost to fix a Ford Rad fan?

Ford charged $520 for a $50 fix. 6 people found this helpful. If you can, check the pressure on the high side of the ac system. If you need a manifold set, they’re only about $25 on Amazon.

What causes a car fan to stop working?

It sends a signal to the vehicle’s computer which turns on the fan. If the sensor is defective it could send an overheat command, thus causing the fan to become active. On some vehicles, disconnecting the electrical connection to the sensor will cause the fan to stop. 16 people found this helpful.

You Might Also Like