How to reassemble a hydro flame arc furnace?
#3remove the entire furnace, pop the spotwelds holding the bottom in place (I did this on one weld with just my jack knife) bend edges out of way, bend bottom out of way and pull out the burner, valve, etc as one unit. To reassemble I would just drill some hols where the spotwelds were, and use a couple pop rivets.
Why does my hydro flame furnace not light?
While the blower motor and fans produce an air stream, the control circuit board would open the gas valve and make the igniter generate sparks. After that, the burner ignites and heat would steadily accumulate in the furnace combustion chamber.
Why does the Atwood hydro flame furnace not light?
After that, the burner ignites and heat would steadily accumulate in the furnace combustion chamber. The air stream that circulates through the outlets would be warmed by the heat until the set temperature is reached.
While the blower motor and fans produce an air stream, the control circuit board would open the gas valve and make the igniter generate sparks. After that, the burner ignites and heat would steadily accumulate in the furnace combustion chamber.
#3remove the entire furnace, pop the spotwelds holding the bottom in place (I did this on one weld with just my jack knife) bend edges out of way, bend bottom out of way and pull out the burner, valve, etc as one unit. To reassemble I would just drill some hols where the spotwelds were, and use a couple pop rivets.
After that, the burner ignites and heat would steadily accumulate in the furnace combustion chamber. The air stream that circulates through the outlets would be warmed by the heat until the set temperature is reached.
Can a gasvalve and burner work on a furnace?
The gasvalve and burner should all come out with a bit of fiddling, holding your mouth right etc. Just be patient, take your time, and don’t force anything. OK, that won’t work, was just out looking at my old one. I see 3 options for you.
How does a hydro flame furnace keep you warm?
Upside down radiated the heat out in a Circle. Open Roof vent a little & Turn burner on. Kept us warm for Years. Might do the Same in trailer. There is an Exhaust Vent above Stove & I can open Roof Vent for fresh Air. Just something to take the Chill off. I can take the Cold but not the Heat. I don’t like sitting in Camper with A/C on all Day.
Why is the igniter on my hydro furnace not working?
If the battery is depleted, the control circuit board would not be able to transmit orders to the control circuit board due to energy shortage. As a result, the valve and the igniter remain inactive. For most of the time, you could determine whether the RV battery is consistently providing juice to the furnace or not by using the multimeter.
Where is the hydro flame on my spotty Sportster?
The Furnace in My 1968 Spotty Sportster is a Hydro Flame. It hangs on the end of Cabinet where stove & oven are. It is Vented out side behind the door. Since there is no battery in the Camper I was wondering if it worked by convection. It looks like it has some kind of Thermostat on outside of Heater.
