How to wire reset thermal overload protector?

Nowadays protection is very important in electrical works, and for different Electrical appliances we use different methods and different devices for protection, today i am writing about overload protector and it’s wiring. In this post i am taking about automatic reset thermal overload protector which we use for single phase load.

How to remove a thermal protector from a light fixture?

Cut the thermal protector’s wires with wire cutters to remove the old thermal protector. Use wire strippers to remove about 3/4 inch of the insulation from the wires left in the fixture.

How to repair a heat sensor in a recessed light fixture?

Use wire strippers to remove about 3/4 inch of the insulation from the wires left in the fixture. Connect one wire from the replacement thermal protector to one of the wires from the original thermal protector by installing a twist-on wire connector onto the two wires.

What to do if your Norcold resets red LED?

LED ON: If the red LED is on, some of these kits have been reset by Norcold users when they can not get into a Norcold repair facility. Our customers have identified the area above the LED where a strong magnet may be applied to the box to try and reset it, we recommend having a qualified Norcold technician perform all repairs.

Cut the thermal protector’s wires with wire cutters to remove the old thermal protector. Use wire strippers to remove about 3/4 inch of the insulation from the wires left in the fixture.