Is there a vacuum flush in a motorhome?
This motorhome has a half bath mid-coach and a full bath across the back. Both commodes use a vacuum flush system – sounds just like the commode in a commercial airliner. Whooooosh! The last time out, there was a continuous noise that I assume is the pump that creates the vacuum pressure.
Where is the nearest Jayco dealership in Fleetwood?
The nearest is a Jayco dealer (about 25 miles) where I took our Class C. The nearest Fleetwood dealer is over 200 miles away. Dang! Our 2008 Pace Arrow has a switch in the 1/2 bath to turn the Vacu-Flush off. When we were having problems with ours we would turn it on for a minute or so to build up vacuum to flush toilet then shut system off.
Why is Bounder the motor home that really works?
Maximum Functionality Bounder is known as “The Motor Home That Really Works” because it provides straightforward functionality. Built for Long Trips Go right ahead and plan that cross-country journey. We built Bounder for extended travel.
Why is the toilet seal on my 2012 Fleetwood losing water?
We had the same problem with a brand new 2012 Southwind. It was initially clear that the front toilet was losing water due to the system vacuum. We had the toilet seal replaced by a local technician even though the vehicle was still under warranty (we didn’t have access to a Fleetwood dealership).
Why are there 4 bolts on Fleetwood toilet?
We had Vacuflush service loofa at it. They found that the seal between and the floor was not properly installed by Fleetwood. The toilet is attached worth 4 bolts, these bolts are supposed to be tightened “sequentially’ similarly to tightening the wheel lugs on a car.
How does a vacuflush system work on a toilet?
The bowl is instantly cleared and the waste is moved through the vacuum pump, at 7 feet per second, and pushed to the holding tank. 3. After the flush lever is released, creating a vacuum tight seal at the toilet bowl, the vacuum pump continues to run until the vacuum level is recharged in the system.
How does a vacuum pump work in a toilet?
When the toilet is flushed by pushing down on the foot lever, the vacuum energy stored in the system is released. The change of pressure in the vacuum tank causes the integral pressure switch to activate the vacuum pump.
