What are the common problems with LED strip lighting?
1. LED strip showing the wrong color 2. LED light strip won’t turn on 3. The LED light strip won’t turn off, or can’t completely shut off 4. LED light strip only red or green or blue is working 5. LED light strip remote not working 6. LED light strip connector not working
Why are my flexible strip lights not working?
Indeed, flexible strip lights should not have this problem. If you do not find a damaged resistor, find the four wires that control the three primary colors. The fourth one is for voltage. It could be a manufacturing error with swapped wires. So, you can swap wires until you fix it.
Why is one of the colors on my LED light not working?
If you noticed a color shift at the end of the strip, scroll down to read the most suitable solution. If the wrong color shows up, one of the three primary colors does not activate.
Why does my Epson printer have red paper out?
Red paper out and red ink light flash alternately and green power light is off The printer may have an internal error. Turn off the printer, wait a few seconds, and turn it on again. If the lights are still flashing, contact Epson as described in Where to Get Help.
Why does my slide not retract after new motor?
After the new motor was installed, the slide still would not retract. The “square rods” connected to the motor were detached to assure the new motor was functioning. We found that power to the motor existed only when the “out” part of the slide’s in/out button was pushed. There was no power to the motor when the “in” side of the button was pushed.
What are the colors of the slide out switch?
It makes sense that there is a relay somewhere as the wires on the back of the slide out control switches are different colors (orange “slide in” wire, blue “slide out” wire, and a common purple wire for all three switches). Somewhere the orange and purple wires at the control switch change to green and yellow wires at motor.
Is there an electrical problem with the slide out?
Finding an apparent electrical button, the control panel was removed and the wires for the stuck slide were placed on another slide “in/out” button. Again, there was no power to the stuck slide when the “In” was pushed. The two young mobile repair techs were now perplexed and did not have the skill to trouble-shoot the electrical issue.
Why is my slide out not working on my RV?
You’ll need to make sure you have enough power available for the slide out to function correctly. The slide out could also be misaligned or could be blocked by something in the way. You may need to resort to manually operating your slide out, so it is best to become familiar with the process before an issue comes up.
