What are the lights on the HWH leveling jacks?
The bottom of the unit has four lights in a diamond pattern that represent the front, left, back, and right sides of the calibration unit (see red arrow in the photo below). A light will come on if that side of the unit is lower than the others. The lights work the exact same way as the four lights on the dashboard leveling controls.
What kind of fluid do you use for leveling jacks?
Hello Joe, Typically Fleetwood used the Power Gear leveling system which is now owned by Lippert Components Inc (LCI). According to the Power Gear manual, they recommend the following: Type A automatic transmission fluid (ATF, Dexron III, etc.,)will work satisfactorily.
Why do I need to calibrate my leveling jacks?
A light will come on if that side of the unit is lower than the others. The lights work the exact same way as the four lights on the dashboard leveling controls. When all four lights are out, the unit is level. The need for calibration arises because the motorhome’s jacks extend until the calibration unit is level.
How big does a hydraulic leveling system need to be?
The Hydraulic Leveling System levels and stabilizes an Motorhome quickly using one-touch automatic or semi-automatic leveling. Capable of leveling most Class A to Class C Motorhomes with capacity ranging from 6,000 to 22,000 Pounds. You May Also Need Wheel Chocks and Leveling Ramps
How to troubleshoot RV hydraulic leveling jacks?
Walk around the RV and put eyes on each of the jacks to determine if there are any obvious issues preventing you from getting the jacks retracted. Look closely to see if there is any hydraulic fluid leaking anywhere as well.
Hello Joe, Typically Fleetwood used the Power Gear leveling system which is now owned by Lippert Components Inc (LCI). According to the Power Gear manual, they recommend the following: Type A automatic transmission fluid (ATF, Dexron III, etc.,)will work satisfactorily.
Are there hydraulic leveling jacks on my 2006 Seabreeze?
On our last trip, Dec 2018 with my 2006 National SeaBreeze LX 32′, the hydraulic leveling jacks deployed correctly, but upon leaving they retracted normally, but slow, and then the control panel displayed at least one of them was still down and would sound an alarm when I removed the parking brake.
Why do I not hear the leveling jacks?
If you don’t hear any noise, it could be a power-related issue. It may even be as simple as a blown fuse. However, if you hear the jacks attempting to operate but nothing is happening, it’s likely a more complicated mechanical issue.
