What can I use to get mold out of my basement?
White vinegar is an excellent cleaning ingredient for removing mold from basement walls and anywhere else you may find the unwanted fungus. Undiluted vinegar takes care of around 80% of mold spores, making it highly effective after a couple of uses. It is also safer to use than bleach.
What can I do about dampness in my basement?
Not only does a damp basement create a musty smell throughout a home, but it can also create problems with mold. Professionals can waterproof a basement, but this type of service can be quite expensive. In many cases, the homeowner can reduce dampness and correct the problem in a number of easy ways. 1. Repair Settlement Cracks
What can I put in my basement to get rid of the smell?
White vinegar is another great way to help deodorize the air in the basement. To try this method, all you need to do is fill a few bowls of undiluted white vinegar and place the bowls around the area where you want to remove the odor. Let the bowls sit for 24 hours, and then discard the old vinegar.
How can I repair a crack in my basement?
If the cracks are caused by settlement, they are easy to repair without the professional help. All that is required is a cold chisel, a mallet, patching cement, and a putty knife. Begin by beveling the crack and slightly widening it with a cold chisel, and a mallet.
What’s the best way to remove a basement door?
If that is the case, try soaking the spacer with a good penetrating spray along the length and let it soak. You may need to use a small punch and hammer to get it started.
How can I get the musty smell out of my basement?
Once the mold spots are gone, wipe the surfaces with clean water on a clean sponge and then let air-dry. Neutralize the musty smell in the basement. To remove any lingering musty smell, try the old-fashioned yet effective remedy of setting out a few small bowls of baking soda around the room; baking soda absorbs and neutralizes odor molecules well.
Can a support post be removed from a basement?
The post they support above can be removed only if a new and stronger beam is installed. The new beam must be designed to carry the weight of the floor above over a greater span. To determine the beam’s required size and span limit, you should ask a structural engineer to calculate the load requirements.
How does a basement door on an RV work?
They are hinged like none I have seen before. There is a strip attached to the RV body that appears to have a small tube as part of it and there is a slit in the tube. The door has a smaller tube that appears to slide into the tube on the body strip.
