What to do after you replace a car battery?

What to do after you replace a car battery?

After placing the new battery in the battery tray, secure it with the hold-down or clamping device. This helps to reduce vibration—one of the key contributing factors in premature car battery failure. 11. Check the battery cables for corrosion, and, if necessary, clean them.

What lead do you put on first when changing a car battery?

“Positive first, then negative. When disconnecting the cables from the old battery, disconnect the negative first, then the positive. Connect the new battery in the reverse order, positive then negative.”

How do you condition a new car battery?

How to keep your battery in good condition

1. Change every four years.
2. Check the acid level.
3. Add water carefully.
4. Conduct a battery load test.
5. Clean the battery.
6. Keep cables tied.
7. Don’t leave your car for too long.
8. Keep the battery warm.

How do I reset my remote car starter after changing the battery?

Press and hold the “Lock” button on your fob remote car starter for one second. Turn your key to the “Off” position — the car lights should turn off. Do this within five seconds of turning the key to the “On” position and don’t remove the key once you’ve turned it to the “Off” position.

What should I wear to change my car battery?

Wear protection from sulfate – Make sure you have put on your safety glasses and gloves, this will help keep you away from the sulfate buildup, if there is any. Using the correct size socket with extension and ratchet, remove the bracket that secures the battery to the vehicle, known as a Battery Hold Down.

How long does it take to change the battery in a car?

Start the vehicle – After 60 seconds you can start the car. If the car starts up with no problem and you notice all the lights turn on, you have successfully changed your battery! Now you can input any radio or GPS codes, or if you are using memory saver, now is the time to remove it.

How do you change a negative battery in a car?

The negative battery terminal is usually black and may have a minus sign (-) near it. Remove the plastic cover, if applicable, then loosen the negative cable clamp with a wrench and slide the cable off the terminal. Use a cable tie to secure the negative cable to the engine bay, making sure it doesn’t come into contact with anything metal.