Why does my FID light but not the flame?
The FID sometimes light, sometimes not: The column is installed too far into the detector. Cause:As the detector nut is tightened, it forces the column end into the jet. Solution:If the column is installed too far into the inlet, the make-up flow is blocked and the FID will not operate effectively. In this case, the flame will not typically light.
Why does my pilot light keep going out?
If your pilot doesn’t re-light, won’t stay lit or keeps going out after a short time, you most likely have an issue with the hot water heater thermocouple. This can happen with age. This can happen with age.
What to do when your gas fireplace flame goes out?
It stays lit for 5 to 10 minutes and then the entire heater–both the flame and the pilot–shuts down. It lights again immediately and again, the pilot will stay on but the flame doesn’t come on automatically. I take the fake logs out and clean the pilot assembly (including the nozzle the gas emerges from) every time I refill the tank.
Why is the pilot light not lit on my gas furnace?
Your furnace will still have a flame sensor, but it will be over the burner’s flame. If you have a furnace with a standing pilot light, step 4 won’t happen. Your pilot light will be lit (by you) before any of the other steps happen. Side note: you may want to consider getting a new furnace since yours is very old and inefficient.
Why does the flame stay lit for 10 seconds?
I have a Kenmore gas dryer model 110.76722690. The flame stays lit for 10 seconds or so and then shuts off. The duct work is clean. How would I replace the thermostat if that’s the problem?
What does it mean when your gas fireplace wont stay lit?
Your pilot should be about 90 percent blue, with very little yellow. It should also be touching the surrounding sensors such as the thermocouple and thermopile. If the color of the flame turns yellow or red, it’s a sign of gas contamination. So you’ve checked your pilot light and even reset it, but still, it wont stay lit.
Why does my dryer flame only stay lit for 10 seconds?
The flame stays lit for 10 seconds or so and then shuts off. The duct work is clean. How would I replace the thermostat if that’s the problem? Share it! Click to remove this tagging. Clean the lint screen. Pull the observation plug from the hole that is below the left side of your dryer door so that you can observe the burner assembly.
Why does the gas furnace keep coming on when the pilot light is out?
The flame sensor tells your furnace that the gas is lit. Without this device, your furnace would simply continue to allow gas to flow into your home, even when the pilot light was out. Flame sensors can go bad and occasionally need to be replaced. Poor flame sensor positioning.
